揚州瑞浦DCL-200B無源觸點電動執行器
揚州瑞浦DCL-200B無源觸點電動執行器
a．電位器的電阻值為1K2、5K2。
The resistance valve of the potentionmeter is 1kn, 5KO
b．用手柄轉動動閥門到全閉位置。
Rotate the valve and reach to close the position completely with the handle
C．松開電位器，轉動動電位器齒輪，用*表測量4－5接線端子間的電阻值，使4－5的電阻值到
52以下，緊固電位器固定螺釘。（如果是智能型的七線接插件連接時請測量對RV和RS兩插插孔的電阻值）
Unclamp the potentionmeter rotate the gear wheel of the potentionmeter measure the resistance valve among4-5wiring sons of end with the universal meter nable the resistance valve of 4-under 50, fasten the potentionmeter fixed screw.(if please measuer the resistance value to RV and RS two jake when being that intelligent Line seven connects the plug-in package connection
注：手動操作時，不能過分超出全開，全關的極限位置，轉角過大，會導致其部件的損壞
Note: At the time of manual operation, can t go beyond and is open excessively completel he terminal position that is closed completely. the comer is too big, will cause its part s damage
3．機械限位的調整
Adjustment of the mechanism spacing
